Search results for "Critical current"
showing 10 items of 11 documents
Dynamically stabilized spin superfluidity in frustrated magnets
2020
We study the onset of spin superfluidity, namely coherent spin transport mediated by a topological spin texture, in frustrated exchange-dominated magnetic systems, engendered by an external magnetic field. We show that for typical device geometries used in nonlocal magnetotransport experiments, the magnetic field stabilizes a spin superflow against fluctuations, up to a critical current. For a given current, the critical field depends on the precessional frequency of the texture, which can be separately controlled. We contrast such dynamic stabilization of a spin superfluid to the conventional approaches based on topological stabilization.
Ac field dependence of the susceptibility of Bi2Sr2CaCu2O8 thin films at low dc fields
1996
We have measured the ac field dependence of the ac susceptibility of 400 nm thick Bi2212 thin films at low dc fields 0 ≤μ0Ha ≤ 1 mT in transverse geometry. We show that at reduced temperaturest≤0.85 the ac field dependence can be described by the non-linear Bean model after Brandt as in Y123 thin films. Att>0.85, however, we observe a decrease of the energy dissipation and shielding capability. The critical current density at zero dc field is given byjc−4×1010(1−(T/Tc))2.8±0.1 A/m2.
Critical currents and micro-structure in YBa2Cu3O7−δ thin films
1996
In an attempt to clarify the origin of the large critical current densitiesJ c observed in Laser Ablated and Sputtered YBa2Cu3O7−δ (YBCO) thin films, we make a systematic study of the low temperatureJ c in samples carefully analysed using STM and AFM.J c (B) is determined from torque-magnetometry performed in ring-patterned thin films. Epitaxial YBCO films nucleate in c-axis oriented single-crystalline islands with sizes ranging between 200 and 700 nm. We show thatJ c can be mainly explained by vortex pinning localised in the island boundaries.
Current-driven periodic domain wall creation in ferromagnetic nanowires
2016
We predict the electrical generation and injection of domain walls into a ferromagnetic nano-wire without the need of an assisting magnetic field. Our analytical and numerical results show that above a critical current $j_{c}$ domain walls are injected into the nano-wire with a period $T \sim (j-j_{c})^{-1/2}$. Importantly, domain walls can be produced periodically even in a simple exchange ferromagnet with uniaxial anisotropy, without requiring any standard "twisting" interaction like Dzyaloshinskii-Moriya or dipole-dipole interactions. We show analytically that this process and the period exponents are universal and do not depend on the peculiarities of the microscopic Hamiltonian. Finall…
Unconventional behavior of superconducting nanostructures
2000
Abstract Various aluminium nanostructures have been studied experimentally. Unusual nonmonotonous dependence of the critical current on external magnetic field has been observed. Pronounced nonlocal interaction has been found to decay exponentially on a scale of the superconducting coherence length ξ(T).
Macroscopic persistent currents in laser deposited YBa2Cu3O7 films
1989
We have investigated persistent currents in a superconducting YBa2Cu3O7 ring of about 1 cm diameter, which was deposited as c-axis textured film on a SrTiO3 substrate by laser ablation. The currents were registered, via their magnetic field distribution, with a small vibrating pick-up coil. At 77 K persistent currents with negligible decay over 103 s have been observed below a critical current density jc=0.9×105 A/cm2, both for a field-cooled and a zero-field-cooled sample. This demonstrates that it is possible to fabricate dissipationless devices of such films on a relatively large scale.
Superconducting properties of polycrystalline YBCO prepared by a pyrolytic process
1994
Polycrystalline YBCO was prepared by a pyrolytic process starting from citrate and tartrate precursors. The effect of the precursor on the superconducting properties was investigated by means of magnetic measurements using a SQUID magnetometer, a Vibrating-Sample Magnetometer and an a.c. susceptometer. The critical temperature is not affected by the type of precursor (Tc=85 K for both). On the other hand, the precursor plays an important role on the critical current density, which is found to be an order of magnitude higher in the sample obtained from citrates (Jc(77K, H=0)=2.3·104 A/cm2 and 103 A/cm2 for the from-citrate and from-tartrate sample, respectively).
Preparation and properties of Tl2Ba2CaCu2O8 thin films
1994
Anex situ process has been developed to produce thin superconducting Tl2Ba2CaCu2O8 films. The properties of films grown on different substrates using different annealing regimes were studied. Critical temperatures of 103–107 K were measured on films prepared in a broad range of annealing temperatures on SrTiO3, LaAlO3, and Y-ZrO2 substrates. A critical current density,Jc, of 2×106 A/cm2 at 77 K was measured on LaAlO3. Film morphology was studied by SEM, AFM, and STM.
Ag/(Bi, Pb)-Sr-Ca-Cu-O superconducting tape processing: Solid state chemistry aspects
1993
Abstract Different preparation methods have been used to obtain starting powders used in the fabrication of composite tapes by the powder-in-tube method. The effect of these distinct starting powders on the superconducting properties of Ag/Bi-Sr-Ca-Cu-O monofilament tapes has been investigated. The changes in the physical properties, including the critical current density at 77 K and ac magnetic susceptibility, and microstructure, using optical and electronic microscopy, have been analyzed in relation to the solid state reactions involved in the Bi 2 Sr 2 CaCu 2 O 8+δ and Bi 2 Sr 2 Ca 2 Cu 3 O 10+δ phase transformations.
Magnetic hysteresis in the microwave surface resistance of Nb samples in the critical state
2006
We discuss the hysteretic behavior of the field-induced variations of the microwave surface resistance in superconductors in the critical state. Measurements have been performed in a bulk sample of Nb and a powdered one at different values of the temperature. We discuss a model, based on the Coffey and Clem theory, in which we take into account the flux distribution inside the sample, due to the critical state. The experimental results are justified quantitatively in the framework of our model. We show that by fitting the experimental data it is possible to determine the value of the critical current density and its field dependence.